active partition
英 [ˈæktɪv pɑːˈtɪʃn]
美 [ˈæktɪv pɑːrˈtɪʃn]
网络 活动分区; 引导分区; 激活分区; 活動分區; 启动分割区
双语例句
- When it finds an active partition, it scans the remaining partitions in the table to ensure that they're all inactive.
当找到一个活动分区时，它会扫描分区表中的其他分区，以确保它们都不是活动的。 - The destination system must have at least an equal amount of processors and memory available ( as dictated by the active partition profile) as the host mobile partition.
目标系统必须与主机迁移分区具有相同数量的内存和处理器（在活动分区配置文件已经指定）。 - When this is verified, the active partition's boot record is read from the device into RAM and executed.
当这个过程验证完成之后，就将活动分区的引导记录从这个设备中读入RAM中并执行它。 - It does this by looking through the partition table for an active partition.
它是通过在分区表中查找一个活动分区来实现这种功能的。 - The number of virtual processors, or a dedicated partition â™ s number of processors, can be seen in partition_active_processors.
虚拟处理器的个数（即专用分区中处理器的个数）可以在partitionactiveprocessors中看到。 - Afterwards, you can see in the lshwres command output that the active paging VIOS partition has changed to lpar_2_solchio06.
在此之后，在lshwres命令输出中可以看到激活的分页VIOS分区已经变成了lpar2solchio06。 - Either loader is installed at the MBR or at the first sector of the active primary partition.
加载程序不是安装在MBR中，就是安装在活动主分区的第一个扇区中。 - You can set this variable to the maximum number of active or concurrent user databases for each Lotus Domino partition.
您可以将该变量设置为每个LotusDomino分区的最大活动数据库数量或并发用户数据库数量。 - The active paging VIOS partition of a running partition can be switched using the chhwres command as explained in Paging VIOS partition failover.
可以使用chhwres命令切换正在运行的分区的分页VIOS分区，稍后在分页VIOS分区故障转移一节中解释。 - Then a chhwres command is executed to switch the active paging VIOS partition.
然后，执行chhwres命令切换分页VIOS分区。 - After the services are active ( running), the partition will be able to receive dynamic LPAR commands from the HMC.
当服务处于活动状态（运行）之后，就可以启用分区来从HMC接收动态LPAR命令了。 - This command must be run while the defragmenter is active on a partition to show the defragment operation in progress.
必须在已启动碎片整理程序的分区上运行该命令，来查看正在进行的碎片整理操作。 - After POST, the loader from a ROM loads the boot sector, which then loads the operating system from the active partition.
在POST之后，ROM中的加载程序将载入引导扇区，该扇区随后将从活动分区中载入操作系统。 - However, no matter how much we are divided into districts, either using a SCSI or IDE hard disk drives, hard drives must be the primary partition to set active partition, this is the only way through your system hard disk.
不过，不论我们划分了多少个分区，也不论使用的是SCSI硬盘还是IDE硬盘，都必须把硬盘的主分区设定为活动分区，这样才能够通过硬盘启动系统。 - Not allowed to delete the Active System partition on this disk.
不允许删除这个磁盘上的系统磁盘分区。 - Mark the partition as active by entering a, and enter the partition number when prompted.
以将该分区标记为活动的分区，然后会出现一个提示，这时输入分区号。 - Detected an active partition that was not the one from which this system was started.
检测到一个活动磁盘分区，该系统不是从这个分区启动的。 - Scott Ambler suggested the importance of active stakeholder partition when he mentioned
ScottAmbler提出了项目干系人积极参与的重要性，他说道 - This method brings up concept of active object based on the space partition in virtual maintenance scenario and describes active object's inner status using Finite State Machine. Based on these the virtual maintenance process is described by a state transformation series.
该方法在对虚拟维修场景进行空间划分的基础上，提出了活动对象的概念，并使用有限状态机描述活动对象的内部状态，然后使用活动对象的状态转移序列对虚拟维修过程进行描述。 - Besides, polarization characteristic depends closely upon the internal crystal defect and inhomogeneous crystallization for the active layer of laser as well as the partition ratio of injected carrier.
此外，偏振特性的好坏还与激光器有源层内部晶体缺陷、非均匀性结晶和注入载流子的分配比密切相关。 - Preliminary Analysis of the Active Ingredients of Partition Moxibustion by Pyrolysis Gas Chromatograph
裂解气相色谱对隔物灸作用成分的初步分析 - A method of extensively making use of spontaneous combustion gangue is introduced that is to use it as active mixture, coarse and fine aggregates to produce partition panel.
介绍一种大规模利用自燃煤矸石的方法，即利用其作活性混合材料、粗细骨料生产内隔墙板。 - Investigation into Independent and Active Partition for Hard Disk
硬盘独立活动分区方法探索与实践